ここから本文です
TWO:But, instead, Landor stopped abruptly, rigid with the force of will. "I will wait. Go on," he said. His voice was low and rasping.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:The woman shrugged her round brown shoulders from which the rebozo had fallen quite away, and dropped her long lashes. "No se," she murmured.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:The entire command volunteered, as a matter of course, and Landor had his pick. He took thirty men and a dozen scouts. Cairness rode up and offered himself. They looked each other full in the face for a moment. "Very well," said Landor, and turned on his heel. Cairness was properly appreciative, despite the incivility. He knew that Landor could have refused as well as not, and that would have annoyed and mortified him. He was a generous enemy, at any rate. The volunteers mounted and trotted off in a cloud of dust that hung above them and back along their trail, to where the road, as Landor had said, entered the malpais.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:"We have tea at five," Mrs. Kirby told him, as they finished, and her husband started out to superintend and help with the digging of an acequia."Do you care for it so much that you would not be happy in any other?"

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.